
Most lawn problems we see start with the mower: blades set too low in July, a cut skipped until half the leaf has to come off at once, or the same wheel tracks pressed into wet ground every week. A regular schedule with the right height avoids all three.
Before the first visit we note what is growing in your yard. Across most of Virginia, lawns are tall fescue, a cool-season grass that wants to be kept tall. Sunny yards, especially toward the coast and the North Carolina line, often have Bermuda or zoysia, which are cut much shorter. Many yards have a mix, and the deck height follows whichever grass makes up the lawn.
On a mowing visit
- Every turf area cut at the height agreed for your grass
- Clippings left as a fine mulch, or collected and taken away if you ask
- Trimmer work around fences, mailboxes, trees, posts and bed borders
- Hard edges along the walk, driveway and curb on the agreed schedule
- Clippings blown off paving, steps and the patio before we leave
How short is too short
Tall fescue does well at roughly 3 to 4 inches, raised toward the top of that range through the summer heat so the blades shade the soil. Bermuda is usually kept around 1 to 1.5 inches and zoysia around 1 to 2 inches while they are green and growing.
A good rule for any lawn is to take off no more than a third of the leaf in a single cut. When rain or a missed week lets the grass get ahead, we raise the deck for one visit and bring it back down over the next one or two.
When the mowing season runs
Regular cutting in Virginia typically runs from April through October, with the first cuts in March and the last in November in warmer years and warmer parts of the state. Fescue grows hardest in spring and again in fall; Bermuda and zoysia race through the hot months.
Weekly visits suit most lawns through the main season. An every-other-week schedule is possible, with the trade-off that the grass is longer between cuts in fast-growing weeks. In a dry spell, or once grass stops growing, a visit may be skipped rather than cutting stressed turf; how skipped visits are handled is written into your estimate.
Edging and trimming
Edging is the vertical cut where turf meets concrete. It keeps Bermuda runners and fescue clumps from creeping across the walk and gives the whole yard a finished outline. Trimming covers every spot the mower deck can’t reach, from fence lines to the base of the mailbox.
Trimming happens on every mowing visit. Hard edges along walks and drives don’t grow as fast as the lawn, so they can be cut every visit or every other visit — you choose, and the estimate shows which.
Getting the yard ready
- Leave side gates unlocked and pets indoors on your service day.
- Clear hoses, toys and chairs off the grass the evening before.
- Point out sprinkler heads, low-voltage lights, dog fences or freshly seeded patches.
Common questions
Is it bad to leave clippings on the lawn?
No. Short clippings dry and break down within days and return nutrients to the soil; they do not cause thatch. When the grass is wet or long and clippings would lie in clumps, we collect them instead.
What happens on a rainy service day?
We move the visit to the next dry day. Cutting soaked grass shreds the leaf tips and the mower leaves ruts in soft soil, so waiting a day gives a better result.
Can I have mowing without edging?
Yes. Trimming around obstacles is always part of the visit, but hard-edge cutting along walks and drives can be left out or done less often. The estimate lists exactly what each visit includes.